AF075 Sway Brace Swivel Attachment

{"Brand":"AFCON","Figure Number":"AF075","Material":"Steel/Ductile Iron","Finish":"Plain","Pipe Type":"Steel","Pipe Connection":"Seismic Brace","Solutions":"Mechanical & Plumbing Systems, Commercial & Residential, Data Centers, Industrial, Energy & Power, Mining, Fire Protection, Oil & Gas, Water & Wastewater","Size Range":"Brace Pipe: 1\" through 2\" Sch. 40; Anchor Size: 1/2\"","Service":"A seismic swivel attachment designed to connect brace pipe to the building structure or to a seismic structural attachment. The Sway Brace Swivel Attachment rigidly braces piping systems subjected to horizontal seismic loads.","Approvals":"cULus Listed (UL 203a) and FM Approved (FM 1950-10 & FM 1950-13). Complies with the hanging and bracing requirements listed in NFPA 13.","Features":"Large installation hole in the cast hoop end allows the brace pipe to pass through easily without interference.; Field adjustable design requires no threading of the brace pipe; The set screw design provides a visual indication that the desired torque value has been achieved","Installation Instructions":"Insert anchor through the mounting hole and into the structure or seismic structural attachment.; For connection to Fig. AF085, AF086, AF087, and AF779 seismic structural attachments, the bolt and nuts shall be installed wrench tight (typically finger tight plus 1/4 to 1/2 turns).; For connection to concrete, wood, timber, steel, and other structures, install fasteners per the fastener manufacturer’s installation instructions.; Insert Sch. 40 brace pipe into the cast hoop end. The brace pipe should extend a minimum of 0.50\" past the back of the cast hoop end.; Torque set screw until the head bottoms out on the cast hoop end.; Check the cross bolt and nut and ensure the nut is wrench tight.; Fire Protection applications shall also be installed per the requirements of NFPA 13 and local codes.","Ordering":"Specify brace pipe, figure number, finish and description.","Category":"Support Systems > Seismic Bracing > Seismic Braces"}

Large installation hole in the cast hoop end allows the brace pipe to pass through easily without interference.; Field adjustable design requires no threading of the brace pipe; The set screw design provides a visual indication that the desired torque value has been achieved

Insert anchor through the mounting hole and into the structure or seismic structural attachment.; For connection to Fig. AF085, AF086, AF087, and AF779 seismic structural attachments, the bolt and nuts shall be installed wrench tight (typically finger tight plus 1/4 to 1/2 turns).; For connection to concrete, wood, timber, steel, and other structures, install fasteners per the fastener manufacturer’s installation instructions.; Insert Sch. 40 brace pipe into the cast hoop end. The brace pipe should extend a minimum of 0.50" past the back of the cast hoop end.; Torque set screw until the head bottoms out on the cast hoop end.; Check the cross bolt and nut and ensure the nut is wrench tight.; Fire Protection applications shall also be installed per the requirements of NFPA 13 and local codes.